OrionIR® family
High-pressure version
Rated to 50 bar rather than 5, for a line that cannot be let down to atmospheric pressure just to be measured. Same optics, same 0.1 mL flow cell, same models.
Specification
What changes against the Lab version
Everything not listed here is as published on the specifications page.
The full high-pressure datasheet is being finalised. Ask and an engineer sends the current revision with the configuration that matches your line.
When this is the right one
Petrochemical and specialty-chemical lines that run above a few bar, and any process where installing a let-down for the sake of an analyser would change the chemistry you are trying to measure. The measurement principle is unchanged, so a chemometric model built during evaluation transfers to the pressurised installation.
Datasheet
Request the high-pressure specification
Tell us the line pressure, the stream and the wetted-material constraint, and we send the version of the datasheet that applies.